The IS-6 may not seem like a tank with a great deal of armor by looking at it’s listed stats. However, it’s armor scheme makes good use of angles which results in excellent protection. Keeping in mind that the IS-6’s armor is mainly based on the angles associated with it. Areas not angled are usually the weakest spots to aim at on the IS-6. This guide for World of Tanks IS-6 weak spots breaks down its armor into individual locations based on armor thickness/angle. Factoring in both thickness and angle gives us the effective armor(EA) value. This is the actual thickness that your rounds will need to penetrate.
Frontally the IS-6 is a formidable foe to come across for most tier 8 tanks and lower. Most of the frontal hull armor is difficult to penetrate due to it being heavily angled. The best spot to aim at on the front hull is the lower glacis that sits at 199mm effective armor. Otherwise you will want to aim at one of the turret weak spots. The cupola is only 150mm-177mm effective in the center area. The roof can also be overmatched by 91mm+ caliber guns.
Tier 8 MEDIUM! 2019 - posted in General Discussion: Welcome back to another update in the BEST series! Today I will be going over the seemingly bland pallet that is tier 8 mediums. I will provide my own thoughts on the best tier 8 medium tanks and I apologize in advance if your favorite tier 8 medium is at the bottom of the list.
If you find yourself being face hugged by an IS-6. You can simply fire down into the upper glacis since it isn’t very well angled. After effects cs6 dmg. Try to avoid the slightly thicker driver’s hatch(110mm) since it is tougher than the upper glacis(100mm).
While the side armor is still angled decently the thickness drops enough to where almost the entire side is weak enough for most tanks that regularly face the IS-6 to penetrate it. The exception is a few small locations on the front of the IS-6’s side hull and also a few small spots on the turret. Some tier 6 and 7 tanks might struggle with reliably penetrating a couple areas if you get a low penetration roll but otherwise the IS-6’s side armor is easy to damage.
Much like the side armor the rear armor on the IS-6 is very weak and easy to damage as long as you avoid the tougher spots on the rear turret.
Last year there was a leak that revealed a large number of supertest icons, this is nothing new but I just want to take a closer look at one of vehicles before I go on vacation.
![]()
The T6 to the untrained eye just looks like early Sherman. This is almost correct. The T6 was the projected replacement of the M3 Lee in Feb. 1941. This was right after the production of the M3 started. The main problem with the design of the Lee was that the 75 mm gun was limited in its traverse thanks to wonderfully thought out engineering of the sponson mount. The T6 retained the M3 Lee’s hull with the sponson removed with the protection increased slightly and featured a new turret. By Sept. of 1941 the T6 was ready for testing.
The T6 was armed with the 75 mm M2(but it was designed for the M3 gun) which was capable of -12/+25 depression/elevation. There were also plans to utilize a twin 37 mm gun system, a 105 mm howitzer, 3 .50 cal MGs for AA work, and the British 6 pdr. None of the alternate weapons were further developed for the T6. The engine was the same as the M3 Lee, the Wright R975(13.3 hp/t), but the T6 featured enough space for the Wright G200 engine(~700 to ~960 hp). The T6 also featured 3 .30 cal hull MGs and two of which were in a fixed position, two more .30 cal MGs were located in the turret(coaxial and in the cupola).
![]()
On September 5, 1941 the T6 was accepted into service as the medium tank M4. The first Sherman was only slightly modified from the T6 and later spawned the Tier 5 M4 in WoT and later M4 variants that served on 6 continents.
Carriereditor dmg file. In WoT the T6 would fit as a good tier 4 premium or as a tier 5 regular tank using with the ability to use the 6 pdr or the 105 mm howitzer. As a tier 4 it would have a good gun but would be inferior to the M3 Lee in overall firepower. As a tier 5 the T6 could pose as an alternate tier 5 medium to either the M4 or the M7.
Source: Hunnicutt’s Sherman
817 Dmg For T6 Tank Wot 3
PS
817 Dmg For T6 Tank Wot Free
You know what really gets on my nerves? The T29′s icon that uses the 76 mm gun. Why can’t WG change this to the historical 105 mm that is also much more pleasant to look at? Another similar issue is this image that has the M103 that isn’t armed with the M58 gun. Why must it torment my dreams? Edit:Yeah they fixed it!
817 Dmg For T6 Tank Wot 2
Install dmg without admin. Why must they use a wussy 76 mm gun instead of the actual 105 mm?!
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |